A.20 percent cell overlap
B.four access points detecting a client at -76 dBm or better
C.10 percent cell overlap
D.three access points detecting a client at -75 dBm or better
您可能感興趣的試卷
你可能感興趣的試題
A.at 30mW
B.matched to the antenna gain
C.differing by at least 20 dBi
D.matched to each other
A.access point position， in feet， from a corner of the floor plan
B.SNR coverage map for 802.11a/n
C.data rate map for 802.11a/n
D.percent of coverage by signal
A.TIFF
B.DXF
C.PNG
D.DWG
A.per SSID
B.per access point
C.globally
D.per WLAN and radio
A.Fresnel units
B.decibels
C.EIRP
D.milliamperes
E.ohms
最新試題
Which format can NOT be imported into Cisco WCS Planning Tool？（）
What should be done if Cisco Spectrum Expert Wi-Fi reports a channel utilization of 40 percent onchannel 36， from a source outside of the site？（）
How should the transmit power on an access point and client each be set during a site survey？（）
When planning for VoWLAN capacity during a site survey， how many simultaneous calls can beestimated per 5 GHz channel？（）
When using a lightning arrestor， connect which type of ground wire to a good earth ground？（）
When surveying for VoWLAN， which power level should you base the access point coverage designon？（）
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas？（）
For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey， what are the mostappropriate client test settings to use with the AirMagnet site survey tool？（）
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS？（）
How is attenuation measured？（）