During the installation of the Cisco WCS， an error occurs.
Where will the installation log be found？（）
A.at the root of the installation drive
B.in the Cisco WCS installation directory
C.on the desktop of the server
D.in the Cisco WCS\Logs directory
您可能感興趣的試卷
你可能感興趣的試題
A lightweight access point has been connected to a Catalyst 3550 24-PWR switch， and on power-up the access point fails.
What is the problem with the switch？（）
A.The power supply has inadequate wattage.
B.Power is incorrectly configured on the port.
C.It does not support 802.3af Poe.
D.Power is not enabled on the port.
Two access points running the core feature set are connected to the same switch and are providingguest services.
If PSPF is enabled， what must be enabled on the switch to prevent clients fromseeing one another’s data？（）
A.port-based RADIUS
B.802.1q trunking
C.inline power
D.protected port
A.startup
B.site survey mode
C.lost connection to the controller
D.duplicate IP address
Last December you erected a bridge link between two buildings on your campus. It is now Apriland the foliage in the trees is full， and the bridge link will no longer maintain connectivity.
Which action will most likely solve the problem？（）
A.Change the channel selection.
B.Install higher gain antennas.
C.Raise the antennas.
D.Increase transmitter power.
An 802.1X client cannot authenticate to an autonomous access point configured for multiple
VLANs. The native VLAN does not have an SSID configured.
Which one of the following links being down would prevent the clients from authenticating？（）
A.between the RADIUS and the access point
B.between the client’s VLAN and the WLSE
C.between the native VLAN and the WLSE
D.between the client’s VLAN and the RADIUS
最新試題
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking，but the status LED and Ethernet LED are both off.What does this indicate？（）
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.What is the maximum number of WLAN controllers that you can add？（）
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem？（）
If it is properly deployed， a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller？（）