A. 512
B. 255
C. 1024
D. 4096
您可能感興趣的試卷
你可能感興趣的試題
You are installing a Cisco ONS 15454 SDH in a service provider site. An E3 cable is being connected to a digital cross-connect system.
What is the maximum distance allowed between the two？（）
A. 225 ft
B. 450 ft
C. 655 ft
D. 900 ft
A. An equal amount of working and protect bandwidth is required.
B. DCC bandwidth is not large enough to handle K1/K2 processing.
C. Switch times would exceed 50 ms for an STM-1 MS-SPRing ring.
D. There is not enough bandwidth in an STM-1 ring to justify MS-SPRing protection.
You are provisioning an E-1 circuit on an ONS 15454 SNCP configuration and XC-VXL-10G card.
How many total ports are used within the Low-Order matrix at the source node？（）
A. 0
B. 1
C. 2
D. 3
E. 5
A. It protects signals against node failures between rings.
B. It protects signals against node failure within a single ring.
C. It allows for traffic to be preempted when a ring switch occurs.
D. Traffic can be dropped and continued at interconnecting nodes.
E. It protects preemptible traffic from being dropped when a ring switch occurs.
A customer would like to create a 1：1 protection group with a DS3Ni-12 card.
Where should it be placed in the chassis？（）
A. only Slots 6 or 12
B. only Slots 3 or 15
C. high or low speed slots
D. directly adjacent to the working card
E. high-speed slots only （5/6 and 12/13）
最新試題
Given the formula： （Fiber Attenuation * Km） + （Splice Attenuation * # of Splices） + （Connector Attenuation * # of Connectors） + （Optical Fiber or OADM） + Buffer（Fiber aging）） With regard to SONET/SDH optical calculations， what will the given formula provide？（）
What three in combination are factors that can cause four-wave mixing in fiber-optic cables？（）
If the power is 0 dBm， what is the power in mW？（）
What is the difference between the transmitted power and the sensitivity of the receiver？ （）
If node 2 is accepting line timing from node 1， node 2 will send （） to node 1 as its SSM messge.
What protection method is used in 4F MS-SPRing networks？（）
What are three relevant design considerations when using the 15216 EDFA？（）
Click the Exhibit button. Which type of multiplexer is shown in the exhibit？（）
Click the Exhibit button. What is the maximum allowable loss budget between the ONS 15216 Mux （left side） composite output and the ONS 15216 Demux （right side） composite input， with the optical values given in the exhibit？ （Assume the worst case loss of 4.5 dB for 15216 200 GHz Mux/Demux and ignore power penalties or extra margin.） （）
A VC-4-4c consists of （）.