A.VTP version 2 supports Token Ring VLANs
B.VTP version 2 allows VLAN consistency checks
C.VTP version 2 allows active redundant links when used with spanning tree
D.VTP version 2 reduces the amount of configuration necessary
E.VTP version 2 saves VLAN configuration memory
您可能感興趣的試卷
你可能感興趣的試題
A.VTP mode
B.VTP password
C.VTP revision number
D.VTP pruning
E.VTP domain name
F.None of the other alternatives apply
Refer to the exhibit. VTP has been enabled on the trunk links between all switches within the TEST domain. An administrator has recently enabled VTP pruning. Port 1 on Switch 1 and port 2 on Switch 4 are assigned to VLAN 2. A broadcast is sent from the host connected to Switch 1. Where will the broadcast propagate?（）
A.Every switch in the network receives the broadcast and will forward it out all ports.
B.Every switch in the network receives the broadcast，but only Switch 4 will forward it out port 2.
C.Switches 1，2，and 4 will receive the broadcast，but only Switch 4 will forward it out port 2.
D.Only Switch 4 will receive the broadcast and will forward it out port 2.
A.30 seconds
B.5 minutes
C.1 minute
D.10 seconds
E.5 seconds
F.None of the other alternatives apply
A.A root VTP server
B.A trunk port
C.VTP priority
D.VLAN 1
E.None of the other alternatives apply
A.STP root status
B.VTP mode
C.Negotiation status
D.Management domain
E.Configuration revision number
最新試題
How are STP timers and state transitions affected when a topology change occurs in an STP environment？（）
Which two statements about the various implementations of STP are true？（）
What is the configured priority value of the Vlan105’s group on DS2 ？（）
Refer to the exhibit. Which Virtual Router Redundancy Protocol （VRRP） statement is true about the roles of the master virtual router and the backup virtual router？（）
During routine maintenance， G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However， after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ？ （）
Which three statements are true of the Link Aggregation Control Protocol （LACP）？（）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2？（）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）