A.Quality of Service
B.Trunk configuration
C.Access lists
D.Routing protocol configuration
E.Power over Ethernet
F.DHCP configuration
您可能感興趣的試卷
你可能感興趣的試題
A.Create an IPv4 tunnel and assign the tunnel IPv6 addresses
B.Create IPv4 interfaces on both ends of the network， and use either static routes or a routingprocess to direct IPv6 packets through those interfaces
C.IPv6 packets cannot be encapsulated with IPv4 headers because the addresses are notcompatible
D.Create IFV6 interfaces on both ends of the network， and use static routes to point the IPv4address to those interfaces
E.Use an IPv6 routing protocol like OSPFv3 and assign IPv4 packets to that process
F.Create an IPv4 tunnel and use the tunnel mode ipv6ip command
A.show ip route ∣ to tftp：//192.168.1.1/route.txt
B.show ip route ∣ tee tftp：//192.168.1.1/route.txt
C.show ip route ∣ include tftp：//192.168.1.1/route.txt
D.show ip route ft include tJtp：//19Z168.1.1/route.txt
E.show ip route ∣ redirect tftp：//192.168.1.1/route.txt
A.Link-local address used for next-hop addresses
B.Interface can be added to RIP routing process in either interface configuration mode or in routerconfiguration mode
C.Uses a multicast to send routing updates
D.Use hop count as a metric
E.Distance-vector routing protocol
F.Maximum hop count is 15 with 16 being "unreachable"
A.The default-metric command configured under the appropriate interface
B.The metric parameter in the network command of a routing process
C.The metric parameter in the redistribute command
D.The default-metric command
E.A route-map containing a seed command
F.A route map containing a metric command
A.Designated port
B.Nonswitch port
C.Switch port
D.Nonroot port
E.Nondesignated port
F.Root port
最新試題
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
Drag the DSL local loop topic on the left to the correct descriptions on the right.
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
Authentication is the process of determining if a user or identity is who they claim to be. Refer tothe exhibit. Which statement about the authentication process is correct？（）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）