A.Active mode does not require the client to be specifically confgured
B.Passive mode can survey more than one access point at a time
C.Active mode yields signal-quality information such as packet retries and lost packets
D.Active mode requires more time to survey but yields more information results than passive mode does
您可能感興趣的試卷
你可能感興趣的試題
A.20 percent cell overlap
B.four access points detecting a client at -76 dBm or better
C.10 percent cell overlap
D.three access points detecting a client at -75 dBm or better
A.at 30mW
B.matched to the antenna gain
C.differing by at least 20 dBi
D.matched to each other
A.access point position， in feet， from a corner of the floor plan
B.SNR coverage map for 802.11a/n
C.data rate map for 802.11a/n
D.percent of coverage by signal
A.TIFF
B.DXF
C.PNG
D.DWG
A.per SSID
B.per access point
C.globally
D.per WLAN and radio
最新試題
According to the following statement， can you tell me which term is described？（）It is the air return for an air conditioned system. In most buildings， the area above a drop ceiling orunder a raised floor is used as the air return （source of air） for the air conditioning. Those dropceiling and raised floors are also where wire is often installed. If wire and cable is installed in a dropceiling or raised floor， it is out of sight. If that cable were burning， it would give off toxic fumes.These would be fed to the rest of the building by the air conditioner. As a result， people could beinjured even though they are a long way from the fire.
Which three device types are identified by Cisco Spectrum Expert Wi-Fi finding an Avg PulseDuration parameter？（）
When conducting a wireless voice site survey， which two sizing considerations exist for thecoverage cell？（）
What is a site survey best practice for location-based services？（）
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920， 7921G， and7925G？（）
Which two methods can be used to prevent or reduce RFI from colocated directional antennas（）
What will cause wireless voice devices to perform poorly？（）
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS？（）
For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey， what are the mostappropriate client test settings to use with the AirMagnet site survey tool？（）
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas？（）