A. Traffic is switched from the first node receiving the AIS indication.
B. Traffic is switched from the far side of the failure, allowing handshaking to occur.
C. UPSR traffic is switched from the terminating node, BLSR traffic is rerouted from the originating node in the ring.
D. UPSR traffic is switched from the terminating node, circuit by circuit. BLSR traffic is rerouted from the last reachable node in the ring.
您可能感興趣的試卷
你可能感興趣的試題
A. Each fiber has half of its SONET capacity reserved for protection.
B. Two fibers in the span carry working traffic, while the other two fibers in the span are reserved for protection.
C. The signal is sent simultaneously in both directions around the ring. The receiver determines which fiber to listen to based on signal quality.
D. The signal is sent simultaneously in both directions around the ring. The transmitter determines which fiber has the working bit set for the receiver to acknowledge.
A. DS-1; E1
B. DS-1; STM-1
C. OC-3; STM-1
D. STS-1; STM-1
E. OC-192; STM-192
A.AMI
B.ESF
C.DUS
D.SSM
E.B3ZS
F.B8ZS
A.DUS
B.line timing
C.loop timing
D.internal timing
E.through timing
A. ESF
B. PRS
C. DUS
D. SMC
E. B8ZS
最新試題
SONET Path Terminating Equipment (PTE) requires which three line codes to be supported for DS1 and DS3 circuits?（） (Choose three.)
If the dispersion of a given fiber is 17ps/nm*km at 1550 nm and zero at 1310 nm, then what is the accumulated dispersion of an ITU wavelength after it travels 200 km?（）
Click the Exhibit button. Given the following parameters: transmitter output (min): -2 dBm receiver input (min): -28 dBm 15216 Mux and Demux loss: 4.5 dB 16 channels maximum In which sites shown in the exhibit could the 15216 EDFAs be placed to minimize the number of EDFAs needed?（）
The ONS 15216 is a 32-channel system. The ONS 15216 OADMs are capable of adding and dropping one, two, or four channels. How are the OADMs provisioned to add and drop specific channels?（）
What are two important considerations when using 2- or 4-channel 15216 OADMs?（） (Choose two.)
Which timing mode is appropriate for a SONET NE that is adjacent to a SONET NE using BITS-1 timing source?（）
Why are the 1300 nm and 1550 nm regions of the fiber spectrum primarily used for optical communications?（）
Given the formula: (Fiber Attenuation * Km) + (Splice Attenuation * # of Splices) + (Connector Attenuation * # of Connectors) + (Optical Fiber or OADM) + Buffer(Fiber aging)) With regard to SONET/SDH optical calculations, what will the given formula provide?（）
Which is a legitimate bandwidth matched pair?（）
What is the difference between the transmitted power and the sensitivity of the receiver?（）