多項選擇題What are three factors that limit the maximum distance of an amplified optical signal without regeneration? ()(Choose three.)

A. fiber dispersion
B. signal attenuation
C. transmitter power
D. amplifier bandwidth
E. receiver dispersion tolerance


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題

Click the Exhibit button. When designing a DWDM system with multiple amplified spans, a pre-amp is needed at Site B to (). (Choose three.)

A. offset the OADM loss at site b 
B. overcome the high multiplexer loss at site a 
C. amplify signal levels after the high loss through Fiber Span 1
D. adjust add channels at site B to be at the same level as the passthrough channels
E. ensure that the per channel power is higher than the minimum needed for the post-amp at Site b

2.單項選擇題How is a Thin Film filter fabricated?()

A. The glass core is doped with an Erbium in periodic segments of the fiber.
B. Layers of high index ?and low index ?material are deposited on a glass substrate.
C. Thin layers of silica glass are placed onto wafers to produce a prism-like effect.
D. Fiber is etched with an ultraviolet laser that is precisely spaced for specific wavelength filtering.

4.單項選擇題If the power is 0 dBm, what is the power in mW?()

A.0mW
B.1mW
C.10mW
D.1.5mW

5.單項選擇題Which device creates an OEO conversion?()

A. amplifier
B. attenuator
C. regenerator
D. light emitter
E. optical switch
F. optical receiver
G. fiber-optic cable

最新試題

What three in combination are factors that can cause four-wave mixing in fiber-optic cables? ()(Choose three.)

題型:多項選擇題

Why are the 1300 nm and 1550 nm regions of the fiber spectrum primarily used for optical communications?()

題型:單項選擇題

In order to avoid misconnections due to a failed node in a Bidirectional Line Switched Ring (BLSR), Alarm Indication Signals (AISs) are sent on every channel normally terminating in that node. What is the name of this process?()

題型:單項選擇題

What are three factors that limit the maximum distance of an amplified optical signal without regeneration? ()(Choose three.)

題型:多項選擇題

What are two important considerations when using 2- or 4-channel 15216 OADMs?() (Choose two.)

題型:多項選擇題

SONET Path Terminating Equipment (PTE) requires which three line codes to be supported for DS1 and DS3 circuits?() (Choose three.)

題型:多項選擇題

The dispersion of a non-zero dispersion shifted fiber is 6 ps/nm*km at 1550 nm and 10 ps/nm*km at 1610 nm. What is the minimum dispersion compensation required if an L-Band DWDM signal travels through 200 km of fiber and has a dispersion tolerance of 1800 ps/nm?()

題型:單項選擇題

A Channel ID mismatch occurs when ().

題型:單項選擇題

What is the difference between the transmitted power and the sensitivity of the receiver?()

題型:單項選擇題

Which timing mode is appropriate for a SONET NE that is adjacent to a SONET NE using BITS-1 timing source?()

題型:單項選擇題