The switched LAN is shown below：
Study the exhibit above carefully. Switch SW5 is configured as the root switch for VLAN 10 but notfor VLAN 20. If the STP configuration is correct， what will be true about Switch SW5？（）
A.All ports in VLAN 10 will be in forwarding mode and all ports in VLAN 20 will be in standbymode
B.All ports will be in forwarding mode
C.All ports in VLAN 10 will be in forwarding mode and all ports in VLAN 20 will be in blockingmode
D.All ports in VLAN 10 will be in forwarding mode
E.None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
A.IEEE 802.10
B.Misconfigured NIC
C.User configuration
D.IEEE 802.1Q
E.None of the other alternatives apply
A VTP domain has six active VLANs. Without notice， all VLANs except VLAN1 fail. Just prior tothe failure， Switch2 was added to the network.
Which three issues on Switch2 could be the cause？（）
A.Switch2 is configured for only VLAN1
B.Switch2 is a VTP server in a different domain
C.Switch2 is a VTP server in the Company domain
D.Switch2 is not a VTP domain.
E.Switch2 has a lower VTP configuration revision number than the current VTP revision
F.Switch2 has a higher VTP configuration revision number than the current VTP revision
A.Physical management of the switch
B.Logical management of the switch
C.In-band management of the switch
D.Out-of-band management of the switch
A.Reload the active VLAN configuration
B.Clear the affected port and bring it up again
C.Explicitly set the trunk for the VLAN to be on
D.Remove all the VLANs set
A.The link is using IEEE 802.1Q protocol
B.The link is using IEEE 802.1E protocol
C.Spanning tree is disabled
D.Not enough information to determine
E.The native VLAN information is identical at each end of the link
F.The native VLAN information is different at each end of the link
最新試題
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
Study the exhibit carefully.Routers A and B are customer routers. Routers 1， 2， 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true？（）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Authentication is the process of determining if a user or identity is who they claim to be. Refer tothe exhibit. Which statement about the authentication process is correct？（）
Study the exhibit carefully. The Cisco IOS IPsec High Availability （IPsec HA） Enhancementsfeature provides an infrastructure for reliable and secure networks to provide transparent availability of the VPN gateways - that is， Cisco IOS Software-based routers. What are the twooptions that are used to provide High Availability IPsec？（）
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.