Which MST configuration statement is correct? ()
A. MST configurations can be propagated to other switches using VTP.
B. After MST is configured on a Switch, PVST+ operations will also be enabled by default.
C. MST configurations must be manually configured on each switch within the MST region.
D. MST configurations only need to be manually configured on the Root Bridge.
E. MST configurations are entered using the VLAN Database mode on Cisco Catalyst switches.
您可能感興趣的試卷
你可能感興趣的試題
A. MST00
B. MST01
C. the last MST instance configured
D. none
A. Region name
B. Configuration revision number
C. VLAN instance map
D. IST STP BPDU hello timer
E. CST instance map
F. PVST+ instance map
Which of the following specification will allow you to: associate VLAN groups to STP instances so you can provide multiple forwarding paths for data traffic and enable load balancing? ()
A. IEEE 802.1d (STP)
B. IEEE 802.1s (MST)
C. IEEE 802.1Q (CST)
D. IEEE 802.1w (RSTP)
Which of the following specifications is a companion to the IEEE 802.1w Rapid Spanning Tree Protocol (RSTP) algorithm, and warrants the use multiple spanning-trees? ()
A. IEEE 802.1s (MST)
B. IEEE 802.1Q (CST)
C. Cisco PVST+
D. IEEE 802.1d (STP)
E. None of the other alternatives apply
pany uses MSTP within their switched LAN.
What is the main purpose of Multiple Instance Spanning Tree Protocol (MSTP)?()
A. To enhance Spanning Tree troubleshooting on multilayer switches
B. To reduce the total number of spanning tree instances necessary for a particular topology
C. To provide faster convergence when topology changes occur in a switched network
D. To provide protection for STP when a link is unidirectional and BPDUs are being sent but not received
E. None of the other alternatives apply
最新試題
During routine maintenance, it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time, DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ? ()
How are STP timers and state transitions affected when a topology change occurs in an STP environment?()
What two things will occur when an edge port receives a BPDU?()
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method?()
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2?()
Which three statements are true of the Link Aggregation Control Protocol (LACP)?()
What is the configured priority value of the Vlan105’s group on DS2 ?()
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2?()
Which two statements are true when the extended system ID feature is enabled? ()